Loading...
Loading...
[root@xstgsano01 dr]# ./setup-dr-primary.shSetting up SANnav Management Portal Disaster Recovery (DR) feature. Note that while this is going on, the SANnav server will be stopped and then restarted. It is recommended that you take a backup of the current SANnav before proceeding with the disaster recovery setup. Ensure that the standby server planned for Disaster Recovery (DR) does not have SANnav currently installed.Press Enter to proceed with DR setup, or press Ctr+C to exit the setup to take a backup of the current SANnav.Enter a valid IPv4 address for the standby Node. If the default SSH port of standby node is not set to the default port (i.e. port 22), please enter the IPv4 Address and the SSH port separated by a colon (e.g. 12.3.4.5:123) 10.x.x.x:6022IP Address 10.x.x.x is not reachable. There is an SSH connection between primary and standby servers. Port 6022 is open. Firewall ports are open - page 51 - Table 18. https://techdocs.broadcom.com/content/dam/broadcom/techdocs/us/en/pdf/fc-networking/software-sannav/sannav-240x-mp-install.pdf (External Link)
Ping (ICMP) between the primary and standby nodes must be enabled.
The scripts ran successfully after enabling the ping.
Click on a version to see all relevant bugs
Dell Integration
Learn more about where this data comes from
Bug Scrub Advisor
Streamline upgrades with automated vendor bug scrubs
BugZero Enterprise
Wish you caught this bug sooner? Get proactive today.