Overview

To power on the press: A message on the Control Center displays while the Fuser warms up and the press runs a system check You can program the press for a job during this time and the printing process starts automatically when the press is ready. The press automatically goes into Power Saver Mode after a set number of idle time lapses The Administrator sets this amount of time When you operate the Control Center or send a job to the press, the system automatically exits the Power Saver Mode. Locate the white power button on the right side of the press near the Control Center. Press the power button to the On position. A message on the Control Center displays while the Fuser warms up and the press runs a system check You can program the press for a job during this time and the printing process starts automatically when the press is ready. The press automatically goes into Power Saver Mode after a set number of idle time lapses The Administrator sets this amount of time When you operate the Control Center or send a job to the press, the system automatically exits the Power Saver Mode.