Overview

Note : To perform this procedure, the Suction Filter is required, contact support. Press the Main Power switch, located behind the Front Cover, to the off position. NOTE: Make sure the Touch Screen goes blank Open the Front Cover. Press the secondary power switch below the Control Panel to the Off (O) position, then wait 10 seconds after the touch screen goes dark before proceeding A warning message will be displayed on the Touch Screen that the printer is powering off. Open the Left Door. Lift up on the release lever on Door A to open the door. Grasp the tab of the suction filter and remove the used filter The filter is located behind the cover near the bottom, left. Remove the new suction filter from its packaging. Insert the new filter into the printer. Close Door A. Press the Main Power switch, located behind the Front Cover, to the on position. Close the Front Cover. Press the Secondary Power switch, located on top of the printer, to the on position. Dispose of the suction filter as normal office waste or recycle the suction filter it in accordance with local regulations.