Overview

Note: Two optional office finishers are available for the printer Use the procedure for the finisher installed on your printer If your finisher front door swings down, use the procedure for the Office Finisher In contrast, if your finisher front door swings to the right, use the procedure for the Office Finisher LX. WARNING: Do not perform this procedure while the printer is printing. Replace Staples in the Booklet Maker of the Office Finisher LX Caution: Do not perform this procedure when the printer is printing. Open the finisher front door. Reach into the finisher cabinet and pull the stapler assembly toward you until it stops. Push the stapler assembly to the right as shown. To remove the staple cartridge, grasp the orange handle, then pull it firmly toward you. Pinch both sides of the staple pack and remove the staple pack from the cartridge. Insert the front side of the new staple pack into the staple cartridge, then push the rear side of the new staple pack into the cartridge. Grasp the new staple cartridge by the orange handle, then insert the cartridge into the stapler assembly until you hear a click. Close the finisher front door. Open the finisher side cover. If the staple cartridges are not visible, grip the vertical panels at the left and right of the opening and slide them to the center. Hold the tabs on both sides of the staple cartridge and pull the cartridge out of the finisher. Hold the tabs on both sides of the new staple cartridge and insert it into the original position in the finisher. Note: If you have trouble inserting the cartridge, ensure that the staples are positioned correctly in the cartridge. Note: The booklet maker uses two staple cartridges Booklet stapling requires that both staple cartridges contain staples. Repeat the procedure for the other staple cartridge. Close the booklet maker side cover.