Overview

The printer has a single multifunction button on the control panel The Power/Wake button restarts, powers up, or powers down the printer This button also enters and exits low-power mode, and flashes when the printer is in power-saver mode. CAUTION: Do not use warm water or cleaning solvents to remove Toner (Dry Ink) from your skin or clothing This will set the Toner and make it difficult to remove If any Toner gets on your skin or clothing, use a brush to remove the Toner, or wash it off with cold water and mild soap.   Video-How to replace transfer belt          12 Use the handle on both top left and right of the transfer belt and completely pull the transfer belt out of the printer.    13 Remove the new transfer belt from packaging.    14 Used the top left and right handle to lift and insert the transfer belt.    15 Push it in until it clicks.    16 Turn the 2 thumbscrews clockwise to lock the transfer belt.    17 Reinsert the waste cartridge.    18 Press the waste cartridge toward the printer, until it clicks into place.    19 To lock the waste cartridge, rotate the waste cartridge lock lever 90 degrees clockwise.    20 Close the printer front cover.    21 Close door A.    22 Turn on the printer. At the printer control panel, press the Power/Wake button, then touch Power Off. Open the front door of the printer, then press the power switch off. CAUTION: Do not unplug the power cord while the printer powers down. Once the printer is completely powered off, unplug the power cord from the wall outlet. Remove the waste cartridge. To unlock the waste cartridge, rotate the waste cartridge lock lever 90 degrees counterclockwise. To release the waste cartridge, press the orange tabs as shown. Grasp the handle of the waste cartridge, then pull it out. Place the removed waste cartridge on a level surface, with the openings facing up CAUTION: To avoid toner spills or malfunction, do not lay the waste cartridge on its side. IMPORTANT : Be careful not to spill Toner when handling the Waste Cartridge. Open Door A. Locate the two thumbscrews located on top of the drum cartridges Turn the thumbscrew counterclockwise until it is loosen. Pull the Transfer Belt until it stop and the 2 handles on top are visible.