Info
An intrusion switch is installed on each Apollo 4200 Gen10 Plus, Alletra 4100 and
Alletra 4120 system and alerts are enabled in the BIOS by default. Regardless of whether
the server is powered on or off, an alert is added to the AHS logs when the hood/cover is
removed.
HPE Integrated Lights-Out (iLO) will record this event in the Integrated Management
Log (IML)when the cover is removed, and the System Health LED will change to amber.
Closing the cover will clear the LED amber alert, but iLO will retain the cover alert in
the event log.
Scope
Any HPE Apollo 4200 Gen10 Plus, Alletra 4100 or Alletra 4120 System.
Resolution
HPE recommends clearing the iLO log event after opening the cover.
Clear the cover open event by using the iLO repair event tool as follows:
1: Log into iLO.
2: Select the
Integrated Management Log
tab, shown below, then select the
Intrusion Alert Detection
event. In this example, event ID #351
is shown in yellow in the
Severity
field. Select the event by clicking in the field left
of the
ID
field.
3: Select the Repair Tool, on the upper right next to the CSV ICON, and
Mark as Repaired
.
Repair Tool ICON:
This will change the event severity from yellow to green in the Severity field; see
figure 2 below.
Note: A user can disable the Intrusion logging via the UEFI setting, but this not
recommended.
This advisory will be updated if additional information becomes available.
RECEIVE PROACTIVE UPDATES
: Receive support alerts (such
as Customer Advisories), as well as updates on drivers, software, firmware, and customer
replaceable components, proactively in your e-mail through HPE Support Alerts. Sign up for
Support Alerts at the following URL:
HPE Email Preference
Center
NAVIGATION TIP:
For hints on navigating HPE.com to locate the
latest drivers, patches and other support software downloads, refer to the
Navigation
Tips document.
SEARCH TIP:
For hints on locating similar documents on HPE.com,
refer to the
Search
Tips document.
