Info
On an HPE system running Red Hat Enterprise Linux (RHEL) 7.x, the show DIMM command returns an "N/A" status for all DIMMs installed when running hp-health 10.92 as follows:
# hpasmcli
HPE management CLI for Linux (v2.0)
Copyright 2015 Hewlett Packard Enterprise Development LP.
hpasmcli> show dimm
DIMM Configuration
------------------
Cartridge #: 0
Processor #: 1
Module #: 12
Present: Yes
Form Factor: 13h
Memory Type: 7h
Size: 16384 MB
Speed: 2133 MHz
Status: N/A
Cartridge #: 0
Processor #: 2
Module #: 12
Present: Yes
Form Factor: 13h
Memory Type: 7h
Size: 16384 MB
Speed: 2133 MHz
Status: N/A
Scope
This issue has been observed when running RHEL 7.X on a ProLiant DL380 Gen8 system, but could potentially occur on other ProLiant server platforms running hp-health 10.92.
Resolution
A future version of hp-health will correct this issue.
As a workaround, run any version of hp-health prior to 10.92.
This advisory will be updated when additional solutions become available.
RECEIVE PROACTIVE UPDATES
: Receive support alerts (such as Customer Advisories), as well as updates on drivers, software, firmware, and customer replaceable components, proactively in your e-mail through HPE Support Alerts. Sign up for Support Alerts at the following URL:
Proactive Updates Subscription Form.
NAVIGATION TIP:
For hints on navigating HPE.com to locate the latest drivers, patches and other support software downloads, refer to the
Navigation Tips document.
SEARCH TIP:
For hints on locating similar documents on HPE.com, refer to the
Search Tips document.
