Loading...
Loading...
cEdge C8300-1N1S-6T Flow control go down after reload the cEdge with manual speed "100" on the interface configuration in place.
cEdge C8300-1N1S-6T with manual speed on the interface
1 - Configure the interface for no negotiation auto will get the Flow-Control up. 2 - if auto negotiationis needed, configure it after the workaround point 1 is done. however you need to do this workaround after each reboot.
- Issue been reproduced on the lab as the following order: 1. When auto negotiation is on the Flow-Control is OFF 2. Config Speed manual to 100Mbps on the interface get the Flow-Control ON 3. Reboot the device. 4. Flow-Control goes Off <--- should not. 5. Revert back to auto negotiation. Flow-Control Still OFF 6. Config Speed 100Mbps on the interface get the Flow-Control Back up.
Click on a version to see all relevant bugs
Cisco Integration
Learn more about where this data comes from
Bug Scrub Advisor
Streamline upgrades with automated vendor bug scrubs
BugZero Enterprise
Wish you caught this bug sooner? Get proactive today.