General

---Start of Note Titled: Release-note---

Symptom

When importing endpoints under Administration -> Identity Management -> Identities -> Endpoints via Bulk import of a CSV file none/not all of the endpoints are imported but there is a message stating all were successful.

Conditions

ISE 1.1..1.268 patch 2 or later. The endpoints being assigned to Unknown will import successfully. All other endpoints will not be displayed after the import. 00:00:00:11:11:11, Unknown (will be displayed after import) 00:00:00:22:22:22, Android (will not be displayed after import)

Workaround

Any of the following can be done: 1) Import the endpoints by hand through the GUI. 2) Import the endpoints as Unknown then go in and change the Endpoint Policy membership after the import. 3) Since this is only seen in patch 2 you can roll back to no patches, import the endpoints, then reapply the patch. ---End of Note Titled: Release-note---

Further Problem Description