Symptom
Day zero webui issue: PC failed to get the 192.168.0.x address and thus not allowing to admin to login via webui for day zero operation.
Conditions
Day zero webui may not be working .
Workaround
use CLI/SSH access or console serial cable to connect to router.
Further Problem Description
About: WebUI:
The Web User Interface (WebUI) provides network administrators with a single solution for provisioning, monitoring, and optimizing devices. After you complete the hardware installation, you need to setup the device with a configuration required to enable traffic to pass through the network. On your first day with your new device, you can perform a number of tasks to ensure that your device is online, reachable and easily configured. This is referred to as the Day 0 interface.
About Day 0 Webui Note:
A Day 0 configuration is defined as a device that is fresh out of the box with no startup-configuration.
After the initial Day 0 configuration, the WebUI can be used for day to day configuration.
Effective with IOS-XE Release 17.3.1, the Day 0 Web User Interface (WebUI) will be supported on the IR1101. Day 0 WebUI is supported only on LAN ports. These are FastEthernet ports 0/0/1 ? 0/0/4 on the IR1101. Connect a PC to one of the LAN ports of the IR1101 and boot the router on Day 0. The PC will getting a dhcp ip when we set the client-identifier as webui .
Once the router boots up in Day 0, the PC can connect to the 192.168.0.x network and can access WebUI using the IP address of 192.168.0.1 with any browser. After the configuration is applied through the WebUI, the router will display the message "Day 0 config done. Stopping autoinstall"
This bug is report that the Dayzero webui may not be working.
