Symptom
Identify and show TAM area corruption in the board through show CLI.
The RSP may not boot.
Conditions
Before FPD upgrade on NCS560-4 RSPs, we can check proactively TAM corruption using CLI from sysadmin mode: show control-driver info location .
Seen normally during a power cycle or reload after the IOFPGA is upgraded.
Further Problem Description
Verify
Problem seen below
RP/0/RP1/CPU0:#admin <<<<<<<< login to admin mode
Sat May 1 18:14:40.834 UTC
Last login: Sat May 1 18:11:36 2021 from 192.0.4.4
sysadmin-vm:0_RP1# show control-driver info location 0/RP1 | b Card. <<<<< run this command
Sat May 1 18:13:50.216 UTC+00:00
Card view from local RP:
TAM Memory is corrupted. <<<<<<<<<<<<<<<this is a problem
Do not proceed with IOFPGA upgrade. <<<<<<<< This is a problem
No problem seen below
RP/0/RP1/CPU0:#admin <<<<<<<< login to admin mode
Sat May 1 18:14:40.834 UTC
Last login: Sat May 1 18:11:36 2021 from 192.0.4.4
sysadmin-vm:0_RP1# show control-driver info location 0/RP1 | b Card. <<<<< run this command
Sat May 1 18:13:50.216 UTC+00:00
Card view from local RP:
TAM Memory is not corrupted. <<<<<<<<<<<<<<<this is not an issue
Can proceed with IOFPGA upgrade if required. <<<<<< this is not an issue
