General
show command output does not display correctly
Symptom
sh controller t3 0/0/11
T3 0/0/11 is up.
Hardware is 12xGE-4x10GE-FIXED
Applique type is Channelized T3/T1
No alarms detected.
Framing is Unframed, Line Code is B3ZS, Cablelength Short less than 225ft
BER thresholds: SF = 10e-3 SD = 10e-6
Clock Source is internal
Equipment customer loopback
Data in current interval (0 seconds elapsed):
Near End
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation, 0 P-bit Err Secs
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs
0 Unavailable Secs, 0 Line Errored Secs
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
0 Severely Errored Line Secs, 0 Path Failures
0 AIS Defect Secs, 0 LOS Defect Secs
Far End
0 Errored Secs, 0 Severely Errored Secs
0 C-bit Unavailable Secs, 0 Path Failures
0 Code Violations, 0 Service Affecting Secs
2 Bipolar Violations/Excessive Zero Errors <<< Bipolar Violations from test-set
2 Code Violations Path Errors, 0 B3 Errors
Conditions
When configuring VCoP and injecting bipolar violations into the near end interface from the test set. The ASR920 reports these errors incorrectly on the far-end statistics instead of the near-end.
